Yamaha YFM660FP 2001, Инструкция по сборке

Страница: 22 / 30

–19–
1
1
2
5 6
4
a
Å
ı
H. Starter cable adjustment
1. Remove:
•
Seat
•
Fuel tank side panel (left)
2. Adjust:
•
Disconnect the starter cable
1
from the carburetor
body.
NOTE:
Do not remove the starter plunger
2
from the starter
cable.
•
Measure the starter plunger stroke distance
a
of
the starter lever
3
fully close to fully open posi-
tion. If the distance is out of specification adjust it
as described below.
Starter plunger stroke distance:
15 mm (0.59 in)
Å
Fully closed position
ı
Fully open position
•
Pull back the boot
4
.
•
Loosen the locknut
5
.
•
Turn the adjuster
6
in or out until the correct
distance is obtained.
Turning in Distance increased.
Turning out Distance decreased.
•
Tighten the locknut
5
.
•
Push in the boot
4
.
•
Connect the starter cable to the carburetor.
WARNING
After adjusting the cable, turn the handlebar to
right and left, and make sure that the engine idling
speed does not increase.
3. Install:
•
Fuel tank side panel (left)
•
Seat
I. Idling speed adjustment
1. Start the engine and let it warm up for several
minutes.
2. Check:
•
Engine idling speed
Out of specification
→
Adjust.
Engine idling speed:
1,450 ~ 1,550 r/min
3. Remove:
•
Seat
•
Fuel tank side panel (left)
4. Adjust:
•
Turn the throttle stop screw
1
in or out until
specified idling speed is obtained.
Turning in Idling speed becomes higher.
Turning out Idling speed becomes lower.
5. Install:
•
Fuel tank side panel (left)
•
Seat
1 2
a
J. Throttle lever free play adjustment
CAUTION:
Before adjusting the throttle lever free play, make
sure that the adjusters and locknuts on the
carburetor side are fully tightened. If not, the
throttle does not operate properly.
NOTE:
Engine idling speed should be adjusted properly
before adjusting the throttle lever free play.
1. Check:
•
Throttle lever free play
a
Out of specification
→
Adjust.
Throttle lever free play:
3 ~ 5 mm (0.12 ~ 0.20 in)
2. Adjust:
•
Pull back the adjuster cover.
•
Loosen the locknut
1
.
•
Turn the adjuster
2
in or out until the correct free
play is obtained.
Turning in Free play is increased.
Turning out Free play is decreased.
•
Tighten the locknut.
•
Push in the adjuster cover.
WARNING
After adjusting the free play, turn the handlebar to
right and left, and make sure that the engine idling
speed does not increase.