Yamaha YDX TORC PB65YTL, Инструкция по сборке

Страница: 11 / 16

INSTALLING THE INCLUDED PARTS
– 9 –
79
8. Installing the rear reflector
Install the rear reflector
1
as shown in the illus-
tration, then tighten it together with the stay
2
and screw
3
.
After tightening the screw, attach the cap nut
4
to the tip of the screw.
TIP
8
Adjust the rear reflector
1
so that it is facing
straight backward, then tighten it.
8
Install the rear reflector
1
at a position where
the tire does not hide the surface of the rear
reflector
1
when viewed from the rear of the
bicycle.
8
If the surface of the rear reflector
1
is hidden by
the tire when the saddle position is lowered,
install the rear reflector
1
on the right side of
the rear frame using the fastening band
included.
9. Installing the pedals
Install the pedal
1
to the crank
a
, then tighten
to the specified torque.
TIP
8
Right screw for the right pedal
8
Left screw for the left pedal
10. Installing the battery pack
Check that the battery pack
1
is fully charged
according to owner’s manual procedures, then
install the battery pack
1
.
Insert the seat post far enough that the raise
limit
c
is not visible. If installed at a position at
which the raise limit
c
is visible, the seat post,
clamp, or even frame may break, which could
cause the rider to lose control and fall.
WARNING
1
2
3
4
1
1
Rear reflector 1 B
2
Stay 1 B
3
Screw 1 B
4
Cap nut 1 B
a
1
Tightening torque 40 N·m (4.0 kgf·m, 30 lb·ft)
1
Pedals (left and right)
1
each
B
1
1
Battery pack 1 C