Yamaha YDX-MORO 05, Инструкция по сборке

Страница: 10 / 18

INSTALLING THE INCLUDED PARTS
– 8 –
7
9
5. Installing the front reflector
Install the front reflector
1
, stay
2
, and screw
3
as shown, and then tighten them together to
the specified torque.
TIP
Install the front reflector
1
while adjusting it so that
it faces to the front and making sure that the wires,
etc. do not contact the front reflector.
6. Installing the bell
Install the bell
1
in the shown, then tighten it
with the screw
2
.
7. Routing the wires
Confirm that hoses and wires are routed in
order starting from front to back
Front brake hose
1
Rear brake hose
2
Dropper seat wire
3
Shift wire
4
Display unit lead
5
Switch unit lead
6
Clamp the front brake hose
1
and rear brake
hose
2
with the wire clip
7
at the position
shown in the illustration.
Clamp the front brake hose
1
and dropper seat
wire
3
with the wire clip
8
at the position
shown in the illustration.
Clamp the dropper seat wire
3
and shift wire
4
with the wire clip
9
at the position shown in the
illustration.
Clamp the switch unit lead
6
at the position
shown with the wire clip
0
.
1
2
3
Tightening torque 1.5 N·m (0.15 kgf·m, 1.1 lb·ft)
1
Front reflector 1 B
2
Stay 1 B
3
Screw 1 B
1
2
Tightening torque 0.8 N·m (0.08 kgf·m, 0.59 lb·ft)
1
Bell 1 B
2
Screw 1 B
1
2
3
4
5
6
7
8
9
q
0
Be sure to route the wires as shown in the illus-
tration. If not, they could interfere with handle-
bar operation which could cause loss of
control.
WARNING