YDP-123
Keyboard Stand Assembly
ENGLISH
29
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Remove the following parts from the package.
1.
Attach the side panels to the pedal box.
2.
Attach the rear panel.
TIP
A headphone hanger is included in the YDP-123 package.
You can attach a headphone hanger on the YDP-123 to hang
the headphones (page 12).
Have a Phillips-head (+) screwdriver ready
Assembly Parts
6
×
20 mm long screws
×
4
1
4
×
12 mm thin screws
×
2
3
Cord holders
×
2
6
×
16 mm short screws
×
4
2
4
×
20 mm tapping screws
×
4
4
Pedal box
Rear panel
Main unit
Side
panel
(left)
Side
panel
(right)
Bundled pedal
cord inside
AC power cord
L
Side panel
(left)
Side panel
(right)
(1) Untie and straighten out the bun-
dled cord attached to the bottom
of the pedal box.
Don’t discard the vinyl tie, you’ll
need it later in step 5.
(3) Use the four
6
×
20 mm long
screws
1
to
attach the
pedal box.
(2) Align the sides of the
pedal box with the left and
right side panels.
R
L
(1) Secure the top of the rear panel to
the side panel brackets using two
4
×
12 mm thin screws
3
.
(2) Secure the bottom of the rear panel
to the pedal box using four 4
×
20
mm tapping screws
4
.