Yamaha XVZ13TF 1999, Руководство по обслуживанию

Страница: 258 / 501

4-114
MIDDLE GEAR
ENG
Middle drive gear shim
Thickness (mm)
0.10, 0.15, 0.20,
0.30, 0.40, 0.50
30 Nm (3 m
S
kg)
25 Nm (2.5 m
S
kg)
WARNING
CAUTION:
7. Select:
S
shim(-s) 1
a. Shims can only be selected in 0.05 mm incre-
ments, therefore round off to the hundredths
digit of the calculated thickness and select
the appropriate shim(-s) with the following
chart.
b. For example, the clearance between the
crankcase and the middle driven shaft bear-
ing housing is 0.42 mm. Therefore, the chart
instructs you to round off the 2 to 0. Thus, you
should use one 0.40 mm shim.
Hundredths Rounded value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10
Shims are supplied in the following thicknesses.
8. Loosen:
S
middle driven shaft bearing housing bolts
9. Install:
S
shim(-s)
R
10. Tighten:
S
middle driven shaft bearing housing bolts
11. Measure:
S
middle gear backlash
Out of specification
Refer to “MEASUR-
ING THE MIDDLE GEAR BACKLASH”.
12. Install:
S
bearing retainers 1
Always use new screws.
S
Apply LOCTITE
R
on to the retainer screws.
S
After tightening the bearing retainer
screws, stake them with a center punch.