PERIODIC MAINTENANCE AND MINOR REPAIR
6-27
6
2. Loosen the drive belt puller lock-
nut on each side of the swingarm.
3. To tighten the drive belt, turn the
adjusting bolt on each side of the
swingarm in direction
a
. To loos-
en the drive belt, turn the adjusting
bolt on each side of the swingarm
in direction
b
, and then push the
rear wheel forward.
NOTE:
@
Turn each adjusting bolt the same
amount for proper wheel alignment.
@
4. Tighten the locknuts.
ECA00025
CAUTION:
@
Improper drive belt slack will over-
load the engine. Keep the drive belt
slack within the specified range.
@
5. Tighten the axle nut and the brake
caliper bracket bolt to the specified
torques.
EAU04034
Checking and lubricating the
throttle grip and cable
The operation of the throttle grip should
be checked before each ride. In addi-
tion, the cable should be lubricated or
replaced at the intervals specified in
the periodic maintenance chart.
1. Drive belt slack adjusting bolt (
×
2)
2. Locknut (
×
2)
3. Wheel axle
Tightening torques:
Axle nut:
108.5 ft·lb (15 m·kgf, 150 Nm)
Brake caliper bracket bolt:
34.7 ft·lb (4.8 m·kgf, 48 Nm)
Содержание XV16AC
