Yamaha XSR700 2018, Дополнительное сервисное руководство

Страница: 17 / 96

CABLE ROUTING
– 10 –
1. Wire harness
2. Clutch cable
3. Oil pressure switch lead
4. Oil pressure switch
5. O
2
sensor
6. O
2
sensor lead
7. Rear brake light switch lead
8. Rear brake light switch
9. O
2
sensor coupler
10. Brake fluid reservoir hose
11. Rear brake light switch coupler
12. Rear wheel sensor coupler
13. Oil pressure switch connector
14. Rear wheel sensor lead
A. Route the oil pressure switch lead through the
guide, and then secure the lead by bending the
guide around the lead.
B. Route the oil pressure switch lead to the inside of
the O
2
sensor lead, and then secure the leads by
bending the guides around the leads.
C. Do not pinch the O
2
sensor lead between the pivot
shaft protector and the engine.
D. Fasten the rear brake light switch lead and O
2
sensor lead with the holder.
E. To rear brake caliper bracket
F. Connect the O
2
sensor coupler, and then insert the
projection on the coupler into the hole in the
bracket.
G. Route the brake fluid reservoir hose to the inside of
the frame and above of the leads.
H. Make sure that the wire harness is not pinched
between the pivot shaft protector (right) and the
frame.
I. Route the wire harness to the inside of the bracket
as shown in the illustration so that the harness
does not contact the air filter case bolt flange.
J. Pass a plastic locking tie through the hole in the
frame, and then fasten the wire harness at the
white tape with the tie.
K. Fasten the wire harness with a plastic locking tie
between the fuel tank bracket and the sub-frame.
L. Less than 10 mm (0.39 in)
M. Forward
N. Rearward
O. Inward
P. Outward
Q. Position the end of the plastic locking tie within the
range shown in the illustration.