VS-10/NX-SW10
10
■
TEST PROGRAM MODE (VS-10)
1. Procedure for starting Test Program
With the power turned off, press the POWER key while pressing the VOLUME key and the DSP key simultaneously. This
initiates the Test Program function.
When the Test Program is initiated, “
01
DEST-Ex
” appears on the FL display.
2. Procedure for selecting and executing Test Program
Using the (UP) key and Volume - (DOWN) key, select the Test Program and then press the INPUT key to
execute it.
3. Procedure for canceling Test Program
There are two methods for cancellation.
a. Turn off the power by pressing the POWER key of the main unit or the remote controller.
b. Select the Test Program “
01
DEST-Ex
” and press the INPUT key for execution. (The normal mode will be restored.)
4. Details of the Test Program function
Display
01
DEST-Ex
Function
Destination display/ test program end
Destination display
J:Ja
J (Japanese)
Ex
Ex models
02
Fact.Test
Factory test mode
This test mode is used for factory inspection before shipping and is not usually
used.
If the test program has been executed, it is not possible to shift to another test
program.
In such case, cancel the test program.
04
FL
CHECK
FL display light-up check
1
st
time: FL display segments all light up and standby LED lights up.
2
nd
time: Even number segments and digits light up and standby LED lights up.
3
rd
time: Odd number segments and digits light up.
1
st
time
2
nd
time
3
rd
time
03
FL+CLEAR
FL display segments all light up / BACKUP RAM CLEAR
1
st
time: FL display segments all light up and standby LED lights up.
2
nd
time: RAM CLEAR is executed (
RAM
CLEAR
OK
on display*)
* State before shipped out of the factory preset.