Yamaha VK10L, Руководство пользователя

Страница: 70 / 98

8-15
3. Pull 3 the V-belt up over the secondary fixed sheave.
4. Remove the V-belt from the secondary sheave
assembly and primary sheave assembly.
5. Put the new V-belt back on the secondary sheave
assembly only. Do not force the V-belt between the
sheaves; the secondary sliding and fixed sheaves
must touch each other. Measure the V-belt position.
6. If the position is incorrect, adjust the V-belt position
by removing or adding a spacer 4 on each adjusting
bolt 5 .
CD-06E
7. Tighten each adjusting bolt.
Standard V-belt position
a
:
From 1.5 mm (0.06 in) above the edge of the second-
ary sheave to 0.5 mm (0.02 in) below the edge.
V-belt position Adjustment
More than 1.5 mm (0.06 in)
above the edge
Remove spacer
From 1.5 mm (0.06 in)
above the edge to 0.5 mm
(0.02 in) below the edge
Not necessary
(It is correct.)
More than 0.5 mm (0.02 in)
below the edge
Add spacer
Adjusting bolt tightening torque:
10 Nm (1.0 m·kgf, 7.2 ft·lb)
U8FN10.book Page 15 Monday, June 13, 2005 8:54 AM