PERIODIC MAINTENANCE AND ADJUSTMENT
7-32
2
3
4
5
6
7
8
9
EAU24360
Front wheel
EAU24641
To remove the front wheel
WARNING
EWA10821
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Disconnect the speedometer ca-
ble from the front wheel.
2. Loosen the wheel axle holder nuts,
then the wheel axle.
3. Lift the front wheel off the ground
according to the procedure on
page 7-31.
4. Pull the wheel axle out, and then
remove the wheel.
NOTICE:
Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
[ECA11071]
EAU24950
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the wheel axle to the spec-
ified torque.
6. Tighten the axle holder nuts to the
1. Speedometer cable
2. Axle holder nut
3. Wheel axle
1
2
3
1. Speedometer gear unit
1
1. Retainer
Tightening torque:
Wheel axle:
58 Nm (5.8 m·kgf, 42 ft·lbf)
1
✧✷✿✬✥✳ ✦✥
