Operation an
d
important ri
d
in
g
points
6-3
6
sion, an
d
d
rive train, which are
not
d
esi
g
ne
d
to withstan
d
the
shock of shiftin
g
when the
throttle
g
rip is open.
EAU39912
To start out an
d
accelerate
1. Close the throttle.
2. Shift into first gear and release the
shift pedal.
NOTICE:
Always
close the throttle
b
efore shiftin
g
g
ears, otherwise
d
ama
g
e to the
en
g
ine an
d
d
rive train may re-
sult.
[ECA15462]
3. Open the throttle gradually.
4. Once the motorcycle has reached
a speed high enough to change
gears, close the throttle.
5. Shift into second gear and release
the shift pedal.
6. Open the throttle gradually.
7. Follow the same procedure when
shifting to the next higher gear.
EAU16711
To
d
ecelerate
1. Close the throttle and apply both
the front and the rear brakes to
slow the motorcycle.
2. Downshift through the gears and
shift the transmission into the neu-
tral position when the motorcycle
is almost completely stopped.
EAU39921
En
g
ine
b
reak-in
There is never a more important period
in the life of your engine than the first 5
hours of riding. It is also important to
accustom the rider to the motorcycle
during this time. Please read the fol-
lowing information carefully.
Since the engine is brand new, do not
put an excessive load on it for the first
5 hours of operation. The various parts
in the engine wear and polish them-
selves to the correct operating clear-
ances. During this period, prolonged
full-throttle operation or any condition
that might result in engine overheating
must be avoided. However, momen-
tary full-throttle operation under load
(i.e., two to three seconds maximum)
does not harm the engine. Each full-
throttle acceleration should be fol-
lowed with a substantial rest period for
the engine. To allow the engine to cool
down from the temporary buildup of
heat, cruise at a lower engine speed.
After the first 5 hours of operation,
thoroughly check the motorcycle for
loose parts, oil leakage and any other
problems. Be sure to inspect and make
adjustments thoroughly, especially ca-
ble and drive chain slack and loose
spokes. In addition, check all fittings
and fasteners for looseness, and tight-
en if necessary.
NOTICE
ECA10271
If any en
g
ine trou
b
le shoul
d
occur
d
urin
g
the en
g
ine
b
reak-in perio
d
,
imme
d
iately have a Yamaha
d
ealer
check the vehicle.
U2CJ86E0.book Page 3 Tuesday, June 26, 2018 10:28 AM
