Yamaha TT-R125Y, Руководство пользователя

Страница: 62 / 248

6 - 2 6
PERIODIC MAINTENANCE AND ADJUSTMENT
6
EAU23383
Battery
1. Negative battery lead
2. Positive battery lead
The battery is located behind panel B.
(See page 6-6.)
This model is equipped with a VRLA
(Valve Regulated Lead Acid) battery.
There is no need to check the electrolyte
or to add distilled water. However, the
battery lead connections need to be
checked and, if necessary, tightened.
ECA10620
NOTICE
Never attempt to remove the battery
cell seals, as this would permanently
damage the battery.
EWA10760
z z z z z Electrolyte is poisonous and
dangerous since it contains
sulfuric acid, which causes
severe burns. Avoid any contact
with skin, eyes or clothing and
always shield your eyes when
working near batteries. In case
of contact, administer the
following FIRST AID.
z z z z z
EXTERNAL: Flush with plenty
of water.
z z z z z
INTERNAL: Drink large
quantities of water or milk
and immediately call a
physician.
z z
z z z
EYES: Flush with water for 15
minutes and seek prompt
medical attention.
z z
z z
z Batteries produce explosive
hydrogen gas. Therefore, keep
sparks, flames, cigarettes, etc.,
away from the battery and
provide sufficient ventilation
when charging it in an enclosed
space.
z z z z z KEEP THIS AND ALL
BATTERIES OUT OF THE REACH
OF CHILDREN.
To charge the battery
Have a Yamaha dealer charge the battery
as soon as possible if it seems to have
discharged. Keep in mind that the battery
tends to discharge more quickly if the
vehicle is equipped with optional
electrical accessories.
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is turned
to “OFF”, then disconnect the
negative lead before
disconnecting the positive lead.
[ECA16302]
2. If the battery will be stored for more
than two months, check it at least
once a month and fully charge it if
necessary.
3. Fully charge the battery before
installation.
4. After installation, make sure that
the battery leads are properly
connected to the battery terminals.
Cap6_1B2_84E.pmd 7/5/2008, 16:31 26