Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 165 / 472

FRONT FORK
4-66
TIP
Use the side of the rod holder that is marked “A”.
f. Remove the rod puller and rod puller at-
tachment.
g. Install the cap bolt, and then finger tighten
the cap bolt.
TIP
Tighten the cap bolt until it contacts the end of
the damper rod assembly.
WARNING
EWA13670
Always use a new cap bolt O-ring.
h. Hold the cap bolt and tighten the locknut to
specification.
i. Remove the rod holder and fork spring
compression tool.
17.Install:
• Cap bolt
(to the outer tube)
TIP
• Temporarily tighten the cap bolt.
• When to tighten the cap bolt to the specified
torque is after installing the front fork leg to the
vehicle and tightening the lower bracket pinch
bolts.
EAS30210
INSTALLING THE FRONT FORK LEGS
The following procedure applies to both of the
front fork legs.
1. Install:
• Front fork leg
Temporarily tighten the lower bracket pinch
bolts.
TIP
Put the mark “b” to specified length, and then in-
stall the front fork legs to align the mark “b” with
the top of the lower bracket.
2. Tighten:
• Lower bracket pinch bolts
TIP
Tighten each bolt to specification in the order
pinch bolt “1”
→
pinch bolt “2”
→
pinch bolt “1”
→
pinch bolt “2”.
3. Tighten:
• Front fork cap bolt
• Upper bracket pinch bolt
Fork spring compression tool
90890-01573
Fork spring compression tool
YM-01573
Rod holder
90890-01434
Damper rod holder double ended
YM-01434
T
R
.
.
Damper rod locknut
15 N·m (1.5 kgf·m, 11 lb·ft)
4
1
2
3
Installed length (from the top of
the outer tube) “a”
215.0 mm (8.46 in)
T
R
.
.
Lower bracket pinch bolt
20 N·m (2.0 kgf·m, 15 lb·ft)
a
b
1
2