Yamaha SY-77, Руководство по эксплуатации

Страница: 138 / 268

VOICE EDIT MODE
vary across the keyboard. When the cursor is
located at note, you can press F7 (Kbd) and
press a key to enter the new note setting.
Output Level: This sets the output level of each
operator. The output level of a carrier operator
will affect the volume, and the output level of a
modulator operator will affect the tone. Remem-
ber that the input levels of each operator input
In1 and In2 can also be adjusted as explained in
1. ( F 3 ) Algorithm (Input level) (JUMP #233).
Even if the output level of an operator is raised,
it will have no effect on another operator to
which it is connected if the corresponding input
level of the operator is set at 0.
Break Point: The operator output level can be
made to vary depending on the note that is
played. On most acoustic instruments, notes
differ in volume and tone depending on the range
in which they are played. For example the low
notes of a piano are more tonally complex and
louder than the high notes.
Use the four break points to specify how the
operator output level will be adjusted across the
keyboard.
Offset (-127...+127) determines the output
level adjustment for each of the four points
specified by Note.
The four note settings must be in ascending
order. It is not possible to set a break point
to a note lower or higher than the note set-
tings of the neighboring break points.
The following diagram shows how the oper-
ator output level would be adjusted across the
keyboard for the settings shown in the above
LCD.
Each offset is added to the overall operator out-
put level of 80. For example the offset at break
point 1 (E1) is -4, so the resulting operator out-
put level at E1 is 76. The resulting operator
output level is limited to the range of 0... 127.
AFM ELEMENT DATA
4. (F2) AFM operator output (All)
JUMP #242
Summary: Set operator output level while viewing
output levels for all operators. (Output scaling
cannot be set in this job.)
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 04:Output and press (JUMP #242)
F2 (All)
Specify: the output level of each operator
Output Level OP1-OP6 (0...127): Set the out-
put level of each operator. This is the same set-
ting as explained in of the previous section
4. (F1) AFM operator output. The difference is
that here you can view and set the output level
for all six operators at once. However break
point Levels and Offsets cannot be set here.
Remarks: Refer to 4. ( F 1 ) AFM operator output
for details.
Note: In algorithms with two or more carriers, some
Velocity Sensitivity settings may cause distor-
tion. In this case, reduce carrier levels.
126