Yamaha SR230, Руководство владельца/оператора

Страница: 51 / 118

NOTE: Pre-operation checks should be
made each time the boat is used. This
procedure can be accomplished thor-
oughly in a short time. The added safe-
ty and reliability the checks assure is
worth the time involved.
CHECK POINTS
Steering
Make sure the wheel is not loose.
There should not be any free play,
either in-and-out or in rotation. Turn the
steering wheel full-right and full-left to
make sure operation is smooth and
unrestricted throughout the whole
range.
Make sure both jet nozzles change
directions as the steering wheel is
turned. The jet nozzles should point to
starboard (right) when the wheel is
turned right. The jet nozzles should
point to port (left) when the wheel is
turned left. There should not be free
play between the steering wheel and
the jet nozzles.
Throttle
Operate the throttle levers several
times to make sure there is no hesita-
tion in their travel. Operation should be
smooth over the complete range of
motion, and each lever should return
completely to the idle position.
Shifting
Before launching, make sure both jet
pump gates drop down over the jet
nozzles to their stopper positions when
the shift lever is moved to the
“Reverse” position. Also make sure
both jet pump gates return to the full up
stopper position when the shift lever is
moved to the “Forward” position.
O
PERATION
3
3-5
10
20
30
35
40 45
50
55
60
1
2
3
4
5 6
7
8
9
10
11
RPM
x 1000
MPH
1
2
3
4
5 6
7
8
9
10
11
RPM
x 1000
I I I I I I I I I I I
S
E
SE
FUEL
E
F
1/2
PRE-OPERATION
CHECKS
CHECK LIST
Before Operating this Sport Boat, per-
form the following checks:
If any item in the Pre-Operation
check is not working properly, have
it inspected and repaired before
operating the Sport Boat. Otherwise
an accident could occur.
3
O
PERATION
3-4
ITEM CHECK
PAGE
REF.
BEFORE LAUNCH OR OPERATION:
STEERING Check for proper steering operation. 3-5
THROTTLE Check for proper throttle operation. 3-5
SHIFTING Check for proper shift operation. 3-5
FIRE EXTINGUISHER Check readiness of the extinguisher. 3-6
HULL Check the hull for damage or cracks
before launching.
ACCESS PORT CAPS Check for proper installation. 3-6
JET (WATER) Check that no debris is in the intakes 3-7
INTAKES before launching.
FUEL SYSTEM Check fuel system for leaks. 3-7
FUEL AND ENGINE Check fuel and oil level; add as necessary. 3-7
OIL LEVELS
BATTERY Check battery condition, mounting, and connection. 3-7
DRAINAGE SYSTEM Check, and remove all water and fuel residue 3-7
before launching. Be sure drain plugs are tightened.
ENGINE Operate the blower for at least 4 minutes. 3-9
COMPARTMENT Open engine hood and check to be sure no
gasoline vapors are present.
ENGINE HOOD Check that hood latch is secure. 2-14
LIGHTS AND HORN Check lights to be sure they operate. 3-9
Press horn button to be sure it operates.
BIMINI TOP Check that the top is secure. 3-11
AFTER LAUNCH
SWITCHES Check operation of the ignition start switches 3-10
and engine stop switch lanyard.
COOLING WATER Check that water comes out while the 3-10
NOTE: Steering and Shifting Pre-Operation Checks will require two persons, one person to operate
controls and one person to observe proper operation at the stern.
WARNING
*SR230(2003)-OwnMnl 3/21/03 2:09 PM Page 3-4