PREPARATIONS
➤
Connecting speakers
En
20
7.1-channel system
(using presence speakers)
6.1-channel system
■
Connecting speaker cables
Speaker cables have two wires. One is for connecting
the negative (-) terminal of the unit and the speaker, and
the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive terminal.
a
Remove approximately 10 mm (3/8”) of insulation from
the ends of the speaker cable and twist the bare wires of
the cable firmly together.
b
Loosen the speaker terminal.
c
Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
d
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China, Australia and General models only)
a
Tighten the speaker terminal.
b
Insert a banana plug into the end of the terminal.
FRONT
CENTER
S
URROUND
S
INGLE
S
URROUND BACK/BI-AMP
S
PEAKER
S
S
UBWOOFER
CENTER
ZONE2/F.PRE
S
ENCE
EXTRA
S
P
CENTER
1
2
1
2
3
4
5
9
Q
W
The unit (rear)
FRONT
CENTER
S
URROUND
S
INGLE
S
URROUND BACK/BI-AMP
S
PEAKER
S
S
UBWOOFER
CENTER
ZONE2/F.PRE
S
ENCE
EXTRA
S
P
CENTER
1
2
1
2
3
4
5
9
8
When using only one surround back speaker, connect it
to the SINGLE jack (L side).
The unit (rear)
FR
ONT
a
a
b
d
c
+ (red)
- (black)
FRO
NT
a
b
Banana plug
1 2
Speaker connections
3 4 5 6 7 8 9 10
