Yamaha RX-V767, Руководство пользователя

Страница: 19 / 128

CONNECTIONS
Connecting speakers
En
19
3
Check that “SP IMP.” is displayed on the front panel.
4
Press STRAIGHT repeatedly to select a “6
Ω
MIN.”
5
Switch this unit to the standby mode, and then
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
This type of jack can connect to the following speakers or
connection.
1 Remove approximately 10 mm of insulation from the
ends of the speaker cables, and twist the bare wires
of the cables together firmly so that they will not
cause short circuits.
2 Loosen the speaker terminals.
3 Insert the bare wire of the speaker cable into the gap
on the side of the terminal.
4 Tighten the terminal.
■
Connecting the subwoofer
1
Connect the subwoofer input jack to the
SUBWOOFER 1 or 2 jack on this unit with an audio
pin cable.
2
Set the subwoofer volume as follows.
Volume: Set to approximately half volume (or slightly less than
half).
Crossover frequency (if available): Set to maximum.
SPIMP.-8MIN
•
Front L/R speakers
•
Center speaker
•
Surround L/R speakers
•
Surround back L/R speakers
•
Bi-amp connection (Front speaker L/R speakers)
FR
ONT
2 2
3
1
4 4
NOTE
After connection, applying this setting to this unit is required to
activate all speaker connections. With using “Power Amp
Assign” function, you can easily apply the speaker
configuration.
Refer to “Power Amp Assign” (
☞
p. 79 ) for details on using
“Power Amp Assign” function.
VOLUME
MIN MAX
CROSSOVER/
HIGH CUT
MIN MAX
Subwoofer examples