Yamaha RX-V6671, Руководство пользователя

Страница: 19 / 128

En
19
■
Connecting speaker cables
Speaker cables have two wires. One is for connecting the
negative (-) terminal of the unit and the speaker, and the
other is for the positive (+) terminal. If the wires are colored
to prevent confusion, connect the black wire to the
negative and the other wire to the positive.
1 Remove approximately 10 mm of insulation from the
ends of the speaker cable, and twist the bare wires of the
cable together firmly.
2 Loosen the speaker terminal.
3 Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
4
Tighten the terminal.
Using a banana plug
1 Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Push-type speaker terminals
1 Remove approximately 10 mm of insulation from the
ends of the speaker cable, and twist the bare wires of the
cable together firmly.
2 Press down the tab.
3 Insert the bare wires of the cable into the hole in the
terminal.
4
Release the tab.
■
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set “Power Amp Assign”
(p.90) in the “Setup” menu to “5ch BI-AMP” after
connecting the power cable to an AC wall outlet.
FR
ONT
+ (red)
– (black)
FRO
NT
Banana plug
EX
ZO
N
PR
+ (red)
– (black)
Audio pin cable
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. When not making
bi-amp connections, make sure that the brackets or cables are
connected before connecting the speaker cables.
• When using bi-amp connections, surround back speakers
cannot be used.
SPEAKERS
FRONT CENTER SURROUND SURROUND BACK/BI–AMP R L R
R
L
L
SINGLE
SUBWOOFER
SINGLE
ZONE 2/
PRESENCE
EXTRA SP
R L
This unit (rear)
1 2
Speaker connections
3 4 5 6 7 8 9