Yamaha RX-V2065 - AV Network Receiver, Руководство по обслуживанию

Страница: 42 / 163

42
RX-V2065/HTR-6295
RX-V2065/HTR-6295
FRONT CENTER SURROUND SURROUND BACK SUBWOOFER
FRNT : SML 0dB SMALL LARGE LARGE LARGE SWFR
CENTER : NONE LARGE NONE LARGE LARGE SWFR
LFE/B : FRNT LARGE SMALL SMALL SMALL FRONT
Zone2/3 Amp ON LARGE LARGE – ( * 1) – ( * 1) SWFR
Bi-AMP LARGE LARGE LARGE LARGE ( * 2) SWFR
TONE : MAX LARGE LARGE LARGE LARGE SWFR
TONE : MIN LARGE LARGE LARGE LARGE SWFR
SPEAKER 6 ohms LARGE LARGE LARGE LARGE SWFR
( * 1) ZONE2/3 L/R (EXTRA SP1/2 L/R): LARGE
( * 2) Bi-AMP: LARGE
3. HDMI AUDIO
Using the sub-menu, the audio signals input to HDMI IN are selected and output.
*
When selecting “DSD”, be sure to connect an HDMI unit equipped with DSD output function to this unit.
SPDIF
SPDIF signal is output.
Multi (DVD-Audio)
Multi signal is output.
DSD (Direct stream digital)
DSD signal is output.
3 . S P D I F
3 . M u l t i
3 . D S D
4. SPEAKER SET
The analog switch settings for each sub-menu are as shown in the table below.
LARGE: This mode is used for a speaker with high bass reproduction performance (a large unit).
Full bandwidth signals are output.
SMALL: This mode is used for a speaker with low bass reproduction performance (a small unit).
The signals of 90 Hz or less are mixed into the channel specified by LFE/BASS.
NONE: This mode is used for no center speaker.
The center content is reduced by 3 dB and distributed to FRONT L/R.
SWFR: LFE of 5.1 ch signal or LFE/BASS lower than 90 Hz is output through SUBWOOFER OUT.
FRONT: LFE of 5.1 ch signal or LFE/BASS lower than 90 Hz is distributed to FRONT L/R.