Yamaha RX-V1900BL, Руководство пользователя

Страница: 35 / 146

31
En
Optimizing the speaker setting for your listening room
PRE
P
ARA
T
ION
English
y
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears
would be when you are seated in your listening position.
You can use the attached screw of a tripod (etc.) to fix the
optimizer microphone to the tripod (etc.).
2
Check if “START” is selected and then press
8
ENTER
.
3
Press
8
ENTER
to start the measurement.
Loud test tones are output from each speaker during
the measurement. Once all items are measured,
“Measurement Complete” appears.
• During the automatic setup procedure, do not perform any
operation on this unit.
• The measurement is canceled if an error occurs (page 32).
4
Press
8
ENTER
to display the result.
Number of the measured points
MLT
Displays the number of listening positions actually
measured.
Number of speakers
SP
Displays the number of speakers connected to this
unit in the following order:
Front/Back/Subwoofer
Speaker distance
DIST
Displays the speaker distance from the listening
position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level
LVL
Displays the speaker output level in the following
order:
Lowest speaker output level/Highest speaker output
level
“WARNING” and the number of warning messages
appear in the above of “RESULT” if any potential problem
occurs (page 33).
5
Press
8
ENTER
to display the setup results
in detail.
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure in 10 seconds. For more accurate
measurements, we recommended that you get out of the room
or move to the wall where speakers are not around during the
measurement. It takes approximately 3 minutes.
Notes
[]/[]:
[ENTER]:
[ p
AUTO SETUP
SETUP ;;;;;;;;; AUTO
MULTI MEASURE ;;;; 1
START
Up/Down
Start
.
AUTO SETUP
Loud test tones are
output.
Please keep quiet
or leave the room.
Press [ENTER]
AUTO SETUP
Measurement Complete
Press [ENTER]
Note
[]/[]:
[ENTER]:
[ p
AUTO SETUP
RESULT
MLT : 1
SP : 5/4/0.1
DIST: 14.0/17.0ft
LVL : -10.0/+5.0dB
>SET CANCEL
Up/Down
Detail
.
[
p
]/[
[
]:
[ENTER]:
RESULT MULTI MEASURE
Measured at
1 point
Select
Return