En
102
Setup menu items
Menu
Item
Function
Page
Speaker
Auto Setup
Optimizes the speaker settings automatically (YPAO).
40
Manual Setup
Setting Pattern
Registers two speaker setting patterns and switches between them.
104
Setting Data Copy
Copies the “Setting Pattern” parameters in the specified direction.
104
Power Amp Assign
Selects a speaker system.
104
Configuration
Front
Selects the size of the front speakers.
104
Center
Selects whether or not a center speaker is connected and its size.
105
Surround
Selects whether or not surround speakers are connected and its size.
105
Surround Back
Selects whether or not surround back speakers are connected and its size.
105
Front Presence
Selects whether or not front presence speakers are connected.
105
Subwoofer
Selects whether or not a subwoofer is connected and its phase.
105
Extra Bass
Sets the speakers to produce the front channel low-frequency components.
105
Bass Cross Over
Sets the lower limit of low-frequency component produced from speakers of which the size is set to “Small”.
106
Distance
Sets the distance between each speaker and listening position.
106
Level
Adjusts the volume of each speaker.
106
Parametric EQ
PEQ Select
Selects a type of equalizer to be used.
106
PEQ Data Copy
Copies the parametric equalizer values acquired with “Auto Setup” to the “Manual” fields for fine adjustment.
106
Test Tone
Enables/disabled the test tone output.
107
Sound
Lipsync
Adjusts the delay between video and audio output.
107
Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.
108
Max Volume
Sets the maximum volume so that sound is not too loud.
108
Initial Volume
Sets the initial volume for when this receiver is turned on.
108
Pure Direct Mode
Selects whether to output video signals during the Pure Direct mode.
108
Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level in conjunction with volume adjustments.
108
Video
Analog to Analog Conversion
Enables/disables the video conversion between the analog video jacks.
108
Processing
Enables/disables the video signal processing (resolution and aspect ratio).
109
HDMI
HDMI Control
Enables/disables HDMI Control. You can also configure the relevant settings (ARC, TV audio input, etc).
109
Audio Output
Selects a device to output audio.
110
Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when this unit is in standby mode.
110
Содержание RX-A1010
Страница 145: ... 2011 Yamaha Corporation YD503A0 OMEN1 YAMAHA CORPOAATIO I R ...
Страница 180: ......
Страница 181: ......
Страница 182: ...RX A 010 ...