15
RX-797
DPX-1200
RX-797
7. SOFT SWITCH
This menu is used to switch the function settings on P.C.B.
through the software so as to activate the product.
The operation mode can be changed by selecting the sub-
menu and then using the EDIT key.
The protection function follows the P.C.B. settings.
When connected to AC, the unit is initialized to the P.C.B.
setting. Display of each function after initialization varies
depending on settings on P.C.B.
Note) Changing the function setting may hinder the proper
operation.
SW MODE: PCB, MODEL or FNC can be selected.
MODEL SETTING: RX797, RX497 or RX397 can be se-
lected. (SW MODE: Selectable when MODEL has been se-
lected.)
DESTINATION: UC / RL / A or BGE can be selected. (SW
MODE: Selectable when MODEL has been selected.)
TUNER DEST INATION: UC, RL or ABGE can be selected.
(SW MODE: Selectable when FNC has been selected.)
TUNER TYPE: NRM, RDS or XM can be selected. (SW
MODE: Selectable when FNC has been selected.)
ZONE2: NOT or EXIST can be selected. (SW MODE: Se-
lectable when FNC has been selected.)
7.SW
:PCB
7.MODEL
:RX797
7.DEST
:UC
7.TuDst
:UC
7.TuTyp
:XM
7.ZONE2
:EXIST
The condition of ports for model detection
(Not applied to these models.)
Software version of microprocessor
Checksum value of microprocessor
Software modules version of microprocessor
8. MICROPROCESSOR INFORMATION
The version, checksum and the port specified by the
microprocessor are displayed. The checksum is obtained
by adding the data at every 16 bits for each program
area and expressing the result as a 4-figure hexadecimal
data.
* The numeric value in the diagram is for reference.
VER.
Z009
CHECK
SUM:78E2
OPE:06
XM:AB
PORT:
EE
SUM:0000
Checksum value of EEPROM
Tuner Dest
UC
RL
ABG
FM
87.5–107.9MHz/200kHz
87.5–108.0MHz/50kHz
87.5–108.0MHz/100kHz
87.5–108.0MHz/50kHz
AM
530–1710kHz/10kHz
531–1611kHz/9kHz
530–1710kHz/10kHz
531–1611kHz/9kHz
Frequency Range
Comment
The frequency range is selected
with Advanced Set Up