Yamaha R6 YZF600W, Руководство пользователя

Страница: 53 / 108

Operation an d important ri d in g points
6-3
6
EAU77403
Shiftin g
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc. The gear positions are shown in
the illustration.
TIP

To shift the transmission into the
neutral position (
), press the
shift pedal down repeatedly until it
reaches the end of its travel, and
then slightly raise it.

This model is equipped with a
quick shifter. (See page 3-4.)
NOTICE
ECA22523

When shiftin g , press the shift
pe d al firmly until you feel the
g ear shift is complete.

Even with the transmission in
the neutral position,
d o not
coast for lon g perio d s of time
with the en g ine off, nor tow the
motorcycle for lon g d istances.
The transmission is properly lu-
b ricate d only when the en g ine is
runnin g . Ina d equate lu b rication
may d ama g e the transmission.

Except when usin g the quick
shifter, always pull the clutch le-
ver when chan
g in g g ears to
avoi d d ama g in g the en g ine,
transmission, an d d rivetrain.
EAU85370
To start out an d accelerate
1. Pull the clutch lever to disengage
the clutch.
2. Shift the transmission into first
gear. The neutral indicator light
should go out.
3. Open the throttle gradually, and at
the same time, release the clutch
lever slowly.
4. After starting out, close the throt-
tle, and at the same time, quickly
pull the clutch lever in.
5. Shift the transmission into second
gear. (Make sure not to shift the
transmission into the neutral posi-
tion.)
6. Open the throttle part way and
gradually release the clutch lever.
7. Follow the same procedure when
shifting to the next higher gear.
EAU85380
To d ecelerate
1. Release the throttle and apply
both the front and the rear brakes
smoothly to slow the motorcycle.
2. As the vehicle decelerates, shift to
a lower gear.
3. When the engine is about to stall
or runs roughly, pull the clutch le-
ver in, use the brakes to slow the
motorcycle, and continue to
downshift as necessary.
1. Gear positions
2. Shift pedal
2
1
1
N
2
3
4
5
6
UBN6EAE0.book Page 3 Friday, November 12, 2021 10:40 AM