Yamaha QS300, Дополнительное руководство

Страница: 41 / 56

40
MIDI Data Format
(3-6) SYSTEM EXCLUSIVE MESSAGE
(3-6-1) UNIVERSAL NON-REALTIME MESSAGE
(3-6-1-1) GENERAL MIDI MODE ON
F0H 7EH 7FH 09H 01H F7H
Resets the following controllers to the indicated values.
VOLUME 100
PAN Center
PROGRAM CHANGE 1 (Grandpno)
BANK SELECT MSB 0
REVERB DEPTH 4
Pitchbend change 0 (center)
Modulation 0 (off)
Expression 127 (max)
Sustain Switch 0 (off)
SOSTENUTO SWITCH 0 (off)
RPN Null (Internal data remains unchanged.)
Portamento control Reset
MIDI master volume 127 (max)
Pitchbend sensitivity 02 (2 semitones)
Fine tuning 0
Coarse tuning 0
(3-6-1-2) IDENTITY REQUEST (Receive only)
F0H 7EH 0nH 06H 01H F7H (where n is the Device No. But message is valid regardless of device (“omni”)).
(3-6-1-3) IDENTITY REPLY (Send only)
F0H 7EH 7FH 06H 02H 43H 00H 41H ddH ddH 00H 00H 00H 01H F7H
dd; Device Number Code
If QS300: 48 01
If B900: 4C 01
If SDX3000: 62 01
(3-6-2) UNIVERSAL REALTIME MESSAGE
(3-6-2-1) MIDI MASTER VOLUME
F0H 7FH 7FH 04H 01H llH mmH F7H
Changes the Master Volume value, where mm gives the new volume setting. (Byte ll is ignored.)
(3-6-3) PARAMETER CHANGE
(3-6-3-1) MIDI MASTER TUNING
F0H 43H 1nH 27H 30H 00H 00H mmH llH ccH F7H
Changes the Master Tune value, where mm and ll give the new setting, as described below. (Values n and cc are ignored.)
T = M*200/256-100
where T : Actual tuning value (-99 ~ +99)
M : One-byte value, where bits 0 to 3 of mm give the high-order nibble, and bits 0 to 3 of ll give the low-order nibble.
(3-6-3-2) XG SYSTEM ON
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0001nnnn 1n Device Number
01001100 4C Model ID
0aaaaaaa 00 Address High
0aaaaaaa 00 Address Mid
0aaaaaaa 7E Address Low
00000000 00 Data
11110111 F7 End of Exclusive
This message switches the SYSTEM MODE to XG. The message requires approximately 50ms to execute, so sufficient time should be allowed before the next message is sent.
The message resets all controllers. It also resets to their defaults all MultiPart and Multieffect values (see appended tables), as well as the Whole System values denoted by “(XG)” (again,
see appended table).
(3-6-3-3) XG PARAMETER CHANGE
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0001nnnn 1n Device Number
01001100 4C Model ID
0aaaaaaa aaaaaaa Address High
0aaaaaaa aaaaaaa Address Mid
0aaaaaaa aaaaaaa Address Low
0ddddddd ddddddd Data
| |
11110111 F7 End of Exclusive
Data size matches parameter size (2 or 4 bytes). For address and byte count, refer to attached table.
The following four data types can be sent or received. (The unit will send only upon receipt of a Parameter Change Request.)
System data
Multieffect data
(Ignored if Voice Mode)
Multipart data (Ignored if Voice Mode)
Drums setup data