Panel Operation
— HOME screen
15
PX10/PX8/PX5/PX3 Reference Manual
q
Mute indication
Appears when the signal is muted.
w
Volume indication
Shows the settings of the volume knobs.
In Power Boost mode, only channel A setting is shown.
e
VOL/BAL/GAIN indication
Shows what appears at the volume indications (
w
).
• VOL:
Input volume
• BAL:
Output balance
• GAIN:
Total level (gain from the input jack to the speaker output terminal)
r
Level meter
Shows input or output level.
t
Threshold indication
Indicates the thresholds of the limiter on the output level of the speaker processors with
“
>
” and “
<
” while the level meter shows the input level.
y
D-CONTOUR indication
Shows the status of D-CONTOUR.
• OFF:
Nothing appears.
• FOH/MAIN:
“FOH” appears.
• MONITOR:
“MONI” appears.
u
Delay indication
Shows the delay time. When delay is off, nothing appears.
i
Polarity indication
Appears when the polarity is inverted.
o
Filter indication
Shows the cutoff frequency of the filter. When the filter is off, nothing appears.
!0
CONFIG VIEW icon
CONFIG VIEW screen appears when selecting the icon by rotating the main knob and
pressing it.
!1
[
] icon
Operation log appears when selecting the icon by rotating the main knob and pressing it.
Refer to
“Operation log indication” (page 35)
for details on the operation log.
!2
Speaker name, clipping/limiting message
Normally, this shows the name of the speaker that is connected, along with a related mes-
sage if clipping or limiting has occurred.
HOME screen
NOTE
Displayed content depends on the input configuration (routing).
• In Dual mode: Input volume at both channels A and B.
• Other than Dual mode: Input volume at channel A, output balance at channel B.
(In Power Boost mode, only channel A is shown.)
in UTILITY screen–HOME SCREEN screen, which is shown in VOL/
BAL/GAIN indication, input volume or total gain.
NOTE
Input and output can be switched from
in the UTILITY screen.
r
!2
y
t
q
e
u
w
!1
!0
i
o
o
NOTE
The displayed speaker name is the speaker preset recalled with the Configuration Wizard.
NOTE
Rotate the main knob to select the group of D-CONTOUR, delay, polarity and filter indications, and
then press the main knob to call up the TUNING screen.
