36
PSR-S975/S775 Reference Manual
2
St
yles
Step Recording (EDIT)
This section applies to step 4 of the Basic Procedure on
. After selecting a Section and make other
settings on the BASIC page, call up the STEP RECORD display via the instructions below, then carry out
Step Recording.
1) From the BASIC page, while holding down the [F] (REC CHANNEL) button, press one of the [1
]–
[8
] buttons to select the desired channel as the recording target.
2) Use the TAB [
F
] button to call up the EDIT page.
3) If “SYS/EX.” is shown at the position corresponding to the [F] button, press the [F] button to call up the
Channel Edit display.
4) Press the [G] (STEP REC) button to call up the STEP RECORD display.
The Step Recording procedure in the Style Creator is essentially same as that in Song Creator (
),
with the exception of the following points:
• Unlike in Song Creator, the “End” mark position cannot be changed in the Style Creator. This is because set-
ting the Pattern Length on the BASIC page determines the “End” mark position. For example, if you select a
Section of four measures or you set the Pattern Length to “4” on the BASIC page, the “End” mark position is
automatically set to the end of the fourth measure, and cannot be changed.
• Unlike in Song Creator, a Recording channel can be set on the BASIC page. It cannot be set on the EDIT
page.
• Unlike in Song Creator, Chord and Lyrics data cannot be entered. This is because such data is not necessary
for Style playback.
For instructions on Step Recording, refer to
. For information on the EDIT page (called as Event
List display in Song Creator), refer to
Style Assembly (ASSEMBLY)
This allows you to copy channel data as a Source Pattern from another preset Style to the currently created
Style. Use this function if you find a favorite rhythm pattern, bass line, chord backing or phrase from another
Style.
The instructions below apply to step 4 of the Basic Procedure on
. After selecting a Section and make
other settings on the BASIC page, carry out the instructions below.
NOTE
(PSR-S975) An Audio part cannot be copied from another Style.
NOTE
(PSR-S975) If you select an Audio Style as starting data, the Audio part cannot be replaced with different data.
1
Call up the operation display.
[FUNCTION]
→
TAB [
F
] MENU 2
→
[A] STYLE CREATOR
→
TAB [
E
][
F
] ASSEMBLY
2
If necessary, select the Section to be edited.
Even if the Section to be edited has already been selected on the BASIC page, you can change the Section
also on this page. Press the desired Section button on the panel to call up the SECTION window, then
press the [8
] (OK) button to actually enter the selection. If you want to select a fill-in section (which has
no panel button), press any one of the Section buttons and use the [6
]/[7
] buttons to select a fill-
in, then press the [8
] (OK) button.
