background image

The holes on the speaker’s back panels are arranged
so that the speakers can be mounted in either of the
two configurations shown by the following figures.

Upright configuration

Side long configuration

Setting the speakers on a shelf or rack

As shown in the figure, the speakers may be stood in
a vertical or horizontal configuration on a shelf or a
rack, by putting a supplied stand into a hole on the
back of each speaker.

WARNING:
* Each speaker weighs 2 kg (4 lbs. 7 oz.). Do not

mount them on thin plywood or soft wall surface
material, as the screws may come out of the flimsy
surface, causing the speakers to fall down and be
damaged, or result in personal injury.

* Do not fasten the speakers to walls with nails, adhe-

sives, or other unsound hardware. Long-term use
and vibrations may cause them to fall down.

* To avoid accidents resulting from tripping over loose

speaker cables, fix them to the wall.

SPECIFICATIONS

Type .......................................2 way Bass-Reflex type
Speaker Unit........10 cm paper cone woofer (JA1075)

2.5 cm paper cone tweeter (JA05S4)

Input Terminal .............................................Push-type
Nominal Impedance.........................................6 ohms
Frequency Response ...........80 Hz – 20 kHz (–10 dB)
Nominal Input Power............................................50W
Music Input Power..............................................200W
Sensitivity ...................................................90 dB/w/m
Crossover Frequency

Tweeter (Low Cut) ..........................6 kHz, 6 dB/oct.

Dimensions (WxHxD)

......................................210 mm x 297 mm x 100 mm

(8-

1

/

4

” x 11-

1

/

16

” x 3-

15

/

16

”)

Weight..............................................2 kg (4 lbs. 7 oz.)
Accessories...................2 speaker cables (10m each)

2 stands

* Specifications subject to change without notice due

to product improvements.

SETTING UP THE SPEAKERS

Mounting the speakers on a wall

The speakers may be mounted on a wall by using the
holes provided on the speakers’ back panels. Fasten
wood screws into a firm wall or wall support as shown
in the diagram, and hang the holes on the protruding
screws.

Make sure that the screw is caught by a narrow part
of the hole securely.

Tapping screw
(Available at a
hardware store)

Diam. 4~5 mm

Min.
12 mm

7 mm

100 mm

Wall or

wall support

100 mm

Ex.)  When placing

the speaker
upright

Holes

Upright configuration

Side long configuration

Holes
for the
sup-
plied
stand

VU 05290    Printed in Malaysia

Отзывы: