Yamaha NS-C40, Руководство пользователя

Страница: 13 / 18

POWER
VOLUME
0 I0
HIGH CUT
50Hz I50Hz
13
English
1
Set the VOLUME control to minimum.
2
Turn on the power supply to all the components.
3
Play any source and adjust the amplifier’s volume control
to the desired listening level.
4
Turn up the VOLUME control gradually to adjust the
volume balance between this unit and the main speakers.
5
If you prefer, set the HIGH CUT control to the position
where you can obtain the optimum tone balance between
the subwoofer and the main speakers.
Notes
•
Once the volume balance between the subwoofer and the
main speakers is adjusted, you can adjust the volume of
your whole sound system by using only the amplifier’s
volume control.
However, if you change the main speakers NS-M40 to
others, you must make this adjustment again.
•
For adjusting the VOLUME control and the HIGH CUT
control, refer to “FREQUENCY CHARACTERISTICS” on
the next page.
Note about setting the HIGH CUT control
This system is designed so that the optimum tone balance
between the subwoofer and the main speakers is obtained
when this control is set at the point of 80 Hz. However, the tone
balance may change depending on the room size, the distance
from the subwoofer to the main speakers, and so on.
So, if you prefer, turn the HIGH CUT control to set it to a
position where a better tone balance is obtained.
Side panel
1, 4
5
ADJUSTMENT BEFORE USING THE SUBWOOFER
Before using the subwoofer, make an adjustment on the subwoofer to obtain the optimum volume and tone balance between the
subwoofer and the main speakers by following the procedures shown below.