E-
2
ATTACHING THE STANDS
1
2
Procedure:
1
Put the 6mm screw through the large hole on the
stand, and screw it into the speaker at one of the
outside holes on the base of the speaker.
At this time, screw it untightly so that the stand can still
be moved.
2
Put the 4mm wood screw through the other hole on the
stand, and screw it into the other hole on the base of
the speaker.
3
Tighten both of the screws firmly.
4
Attach a pad to the bottom of the end portion of the
stand.
5
Attach the other stands to the other corners of the
base of the speaker in the same way and confirm that
all 4 stands have been firmly attached.
Note:
Be carefull not to apply force to the side of the speaker,
otherwise the speaker may fall causing damage to the
speaker or personal injury.
(L)
(R)
(L)
Front
Back
SUPPLIED ACCESSORIES
Pad x 4
Screw
(6mm) x 4
Stand (R x 2, L x 2)
Wood screw
(4mm) x 4
(L)
(R)
(R)
When placing the speakers, be sure to use the stands to
increase stability.
Note:
• The provided stands are in two types. Two stands are
for the right side and others are for the left side. Attach
each stand to the proper position on the bottom of the
speaker by following the figure below.
• When attaching the stands to the speaker, have
another person support it.
• To attach the stands to the speaker, be sure to lay
down the speaker while the front is facing up. We
recommend using a blanket or cushion (thickness of
3 cm or more) to raise the speaker from the floor.
Use the 8 specified holes located on the base of the
speaker.
3cm
View from the bottom of the speaker
