Yamaha NIKEN GT 2020, Руководство пользователя

Страница: 49 / 108

Instrument an d control functions
3-34
3
NOTICE
ECA26610
Do not d raw power from a DC jack
with the en g ine turne d off. Do not
connect any accessory which uses
more than 12 W (1.0 A). Otherwise
the
b attery may d ischar g e or a fuse
may b low.
To use an auxiliary DC jack
1. Start the engine. (See page 5-2.)
2. Turn the accessory off.
3. Open the auxiliary DC jack cap.
4. Insert the accessory power plug.
5. Turn the accessory on.
TIP

When inserting or removing the
accessory power plug, turn the
accessory off.

When the auxiliary DC jack is not
being used, cover it with the cap.
WARNING
EWA14361
To prevent electrical shock or short-
circuitin
g , make sure that the cap is
installe d when the auxiliary DC jack
is not b ein g use d .
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
this system re g ularly an d have a
Yamaha d ealer repair it if it d oes not
function properly.
UB5BE1E0.book Page 34 Wednesday, October 30, 2019 9:59 AM