Yamaha MT10SPN, Руководство пользователя

Страница: 31 / 134

Instrument and control functions
5-3
1
2
3
4
5
6
7
8
9
10
11
12
13
EAU66040
Turn signal switch “ / ”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “ ”. When re-
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU66030
Horn switch “ ”
Press this switch to sound the horn.
EAU94790
Stop/Run/Start switch “ / / ”
To crank the engine with the starter, set
this switch to “
”, and then push the
switch down towards “ ”. See page
7-2 for starting instructions prior to
starting the engine.
Set this switch to “
” to stop the engine
in case of an emergency, such as when
the vehicle overturns.
EAU91670
Hazard switch “ ”
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
used in case of an emergency or to
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
The hazard lights can be turned on or
off only when the key is in the “ON” po-
sition. You can turn the main switch to
the “OFF” or “LOCK” position, and the
hazard lights will continue to flash. To
turn off the hazard lights, turn the main
switch to the “ON” position and operate
the hazard switch again.
NOTICE
ECA10062
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU94151
Cruise control/YVSL switches
See page 4-6 for an explanation of the
cruise control system.
See page 4-8 for an explanation of the
YVSL.
EAU93611
“MODE” and select switches
Use the “MODE” switch, the MODE up
“
” switch and the MODE down “ ”
switch to change YRC modes or edit
the PWR, TCS, SCS, and ERS settings
from the main screen.
MODE up “ ” - push this switch to
change the selected YRC setting up-
ward.
“MODE” - push this switch to scroll left
to right among the MODE, PWR, TCS,
SCS, and ERS items.
MODE down “ ” - push this switch to
change the selected YRC setting
downward.
TIP

The traction control system can
only be turned off from the main
screen. Select TCS with the
“MODE” switch, then push and
hold the MODE up “
” switch un-
BGG-9-10-E0.book 3 ページ ２０２２年１月２６日 水曜日 午前１１時３７分