Yamaha MT-10 SP 2016, Руководство пользователя

Страница: 24 / 118

Instrument and control functions
4-4
1
2
3
4
5
6
7
8
9
10
11
12
Right
EAU78400
Headlight and Pass/LAP switch
“
/ ” and “ /LAP”
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
While the headlights are set to low
beam, push the switch downward (to-
wards
/LAP) to flash the headlights
and to mark the start of each lap when
using the lap timer.
EAU66040
Turn signal switch “ / ”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “ ”. When re-
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU66030
Horn switch “ ”
Press this switch to sound the horn.
EAU66060
Stop/Run/Start switch “ / / ”
To crank the engine with the starter, set
this switch to “
”, and then push the
switch down towards “ ”. See page
6-1 for starting instructions prior to
starting the engine.
Set this switch to “
” to stop the engine
in case of an emergency, such as when
the vehicle overturns or when the throt-
tle cable is stuck.
EAU66010
Hazard switch “ ”
With the key in the “ON” or “ ” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
ECA10062
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU73951
Cruise control switches
See page 3-3 for an explanation of the
cruise control system.
EAU78391
Select switch “ / ”
This switch is used to change YRC
modes or edit the PWR, TCS, and ERS
settings. (See page 4-11.)
EAU78382
Mode switch “MODE”
Use the mode switch to change YRC
modes or edit the PWR, TCS, and ERS
settings from the main screen.
Push this switch to scroll left to right
among the MODE, PWR, TCS, and
ERS items.
TIP

The traction control system can
1. Stop/Run/Start switch “ / / ”
2. Wheel switch “ ”
1
2
BW8-9-E0_1.book 4 ページ ２０１６年１２月１３日 火曜日 午前１０時３９分