Yamaha MSR100, Руководство пользователя

Страница: 5 / 9

5
ENGLISH
Rear Panel
1
POWER Switch
Turns power to the MSR100 on and off. When the
power is turned on the POWER indicator (
J
)
will light green.
2 INPUT1 Connector
This dual-mode input connector is a balanced
XLR-3-31 type.
The INPUT1 connector can be set for two types of
input: when the sensitivity switch (
C
) is set to
MIC microphone-level signals can be connected
directly to the input; when the sensitivity switch
(
C
) is set to LINE the input accepts line-level sig-
nals such as those from a preamplifier or mixer.
3
Sensitivity Switch
Use this switch to set the sensitivity of the
INPUT1 connector to match MIC (microphone-
level) or LINE (line-level) input signals.
4 INPUT2 and INPUT3 Connectors
The INPUT2 and INPUT3 connectors are unbal-
anced phone jacks for direct connection of line-
level audio signals and musical instruments.
5
LEVEL Controls
Adjust the level of the signals received at the
INPUT1, INPUT2, and INPUT3 connectors (
2
,
4
).
6 EQ Controls
HIGH: The HIGH control adjusts the output level at
10 kHz over a ±6 dB range. Rotate clockwise to
boost or counterclockwise to cut.
LOW: The LOW control adjusts the output level at
60 Hz over a ±3 dB range. Rotate clockwise to
boost or counterclockwise to cut.
7
LINK OUT Connector
This is a “direct output“ connector that outputs a
mix of the signals received at the INPUT1,
INPUT2 and INPUT3 connectors (
2
,
4
).
8 MASTER LEVEL Control
Adjusts the overall output level.
9
CLIP Indicator
The CLIP indicator will light red if excessively
high signal levels cause amplifier clipping. If this
occurs, reduce the level of LEVEL controls (
5
) or
MASTER LEVEL controls (
8
).
J POWER Indicator
Light green when the POWER switch (
A
) is
turned on.
K
AC IN Connector
Connect the supplied power cord here.
①
⑪
⑧
⑥
⑤
②
③
④
⑦
⑨
⑩