65
En
Troubleshooting
English
INTR
ODUCTION
APPENDIX
PRE
P
ARA
T
ION
BA
S
IC
OPERA
T
ION
AD
V
ANCED
OPERA
T
ION
Noise/hum noise is
heard.
Incorrect cable connection.
Connect the audio cables properly. If the problem
persists, the cables may be defective.
—
A DTS-CD is being played back.
1) When only noise is output
If a DTS bitstream signal is not properly input to this
unit, only noise is output. Connect the playback
component to this unit by digital connection and play
back the DTS-CD. If the condition is not improved,
the problem may results from the playback
component. Consult the manufacturer of the playback
component.
2) When noise is output during playback or skip
operation
Before playing back the DTS-CD, display the Option
menu after selecting the input source and set
“Decoder Mode” to “DTS”.
The volume level
cannot be increased,
or the sound is
distorted.
The component connected to the AUDIO
1/2 jacks of this unit is turned off.
Turn on the power of the component.
“Memory Guard!” is
displayed and the
setting cannot be
changed.
“Memory Guard” in “Setup Menu” is set
to “On”.
Set “Memory Guard” to “Off”.
There is noise
interference from
digital or radio
frequency equipment.
This unit is too close to other digital or
radio frequency equipment.
Move this unit further away from such equipment.
—
HDMI™
Problem
Cause
Remedy
See
page
No picture or sound.
The number of the connected HDMI
components is over the limit.
Disconnect some of the HDMI components.
—
The connected HDMI component does not
support high-bandwidth digital copyright
protection (HDCP).
Connect an HDMI component that supports HDCP.
Problem
Cause
Remedy
See
page