Yamaha HTR-6040, Руководство пользователя

Страница: 34 / 93

PLAYBACK
30
En
y
Before performing operations, set the operation mode selector
(
K
) to
AMP
.
1
Turn on the video monitor connected to this
unit.
2
Press
D
INPUT
l
/
h
repeatedly (or press
one of the input selector buttons (
A
)) to
select the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
y
The corresponding input selector button on the remote
control for the currently selected input source lights up for
approximately 5 seconds after you press any buttons on the
remote control, showing which source component is
currently being operated.
3
Start playback on the selected component or
select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 38 for details about FM/AM tuning
instructions.
• See page 41 for details about XM Satellite Radio
tuning instructions.
4
Rotate
8
VOLUME
(or press
J
/
–
) to adjust the volume to the desired output
level.
5
Press
A
PROGRAM
l
/
h
repeatedly (or
press one of the sound field program
selector buttons (
P
) repeatedly) to select the
desired sound field program.
The name of the selected sound field program appears
in the front panel display.
See page 35 for details about sound field programs.
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically
selects the last sound field program used with the
corresponding input source.
• Sound field programs cannot be selected when the
component connected to the MULTI CH INPUT jacks is
selected as the input source (see page 31).
• When PCM signals with a sampling frequency higher than
48 kHz are input, this unit is automatically set to the
“STRAIGHT” mode (see page 36).
• To display information about the currently selected input
source in the OSD, see page 33 for details.
■
A quick guide to contents
Playback
Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
Basic operations
INPUT:DVD
DVR DVD CD XM V-AUX DTV/CBL MD/CD-R TUNER
Currently selected input source
Available input source
Notes
When you want to...
See
page
Enjoy pure hi-fi stereo sound 32
Adjust the tonal quality of the front speakers 32
Adjust the parameters of sound field programs 37
Enjoy the sources with a wide dynamic range at night 33
Use headphones 34
Select a decoder to play back sources with 36
Automatically set this unit to the standby mode 34
Movie Dramatic
Currently selected
surround field program