48
Remote control operation range
Notes
• There should be no large obstacles between the remote
control and the unit.
• If the remote control sensor is directly illuminated by strong
lighting (especially from an inverter type of fluorescent lamp),
it might cause the remote control not to work correctly. In this
case, reposition the unit to avoid direct lighting.
NOTES ABOUT THE REMOTE CONTROL
Battery installation
1.
Turn the remote control over and slide the battery compart-
ment cover in the direction of the arrow.
2.
Insert the batteries (AA, R6 or UM-3 type) according the
polarity markings on the inside of the battery compartment.
3.
Close the battery compartment cover.
Battery replacement
If the remote control operates only when it is close to the unit,
the batteries are weak. Replace all the batteries with new
ones.
Be sure to replace the batteries within about two minutes. If
it takes longer than two minutes, the codes preset for the
remote control will return to the factory settings.
Notes
• Use only AA, R6 or UM-3 batteries for replacement.
• Be sure the battery polarity is correct. (See the illustration
inside the battery compartment.)
• Remove the batteries if the remote control will not be used for
an extended period of time.
• If the batteries have leaked, dispose of them immediately.
Avoid touching the leaked material or letting it come into
contact with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
Remote control
sensor
Within approximately
6 m (20 feet)
1
2
3
01RX-V595a-e/f6
6/24/99, 11:46 AM
48
