81
3. See “Reading the charging status”, and check that the battery charger is charging the battery pack.
4. The battery capacity indicator lamps will light up one by one until all four are on. Then, when charging is
complete, all of the lamps will go off.
5. Confirm that charging is complete, and then disconnect the charging plug from the battery pack. How to
disconnect the plug (see the left figure)
1 Grasp the lock-release ring.
2 Pull it out straight.
6. Place the cap of charging inlet on the battery pack’s charging connector.
Never handle the power plug, charging plug or touch the charger contacts with wet hands.
This could result in electric shock.
TIP
• Charging will start automatically.
• If the display unit is turned on while the battery pack is charging, all normal displays will be shown,
including the battery capacity indicator, but the assist system will not function.
• When the battery pack is connected to the battery charger, battery charger lamp will flash at
approximately 0.2 second intervals to indicate that charging is preparing to charge the battery pack. Leave
it as it is and charging will start normally.
1
2
Lock-release ring
[CHARGING THE BATTERY PACK REMOVED FROM THE BICYCLE]
1. Turn the display unit off.
2. Insert the key into the battery lock, and turn it clockwise to release the battery lock.
3. Remove the battery pack.
Use both hands when removing the battery pack, being careful not to drop it. Dropping the
battery pack on your foot could result in injury.
English
