Yamaha Fazer FZ8-SA, Руководство по обслуживанию

Страница: 119 / 610

CABLE ROUTING
2-70
1. Brake hose (hydraulic unit to rear brake
caliper)
2. Rear wheel sensor lead
3. Rear wheel sensor
4. Clamp
5. Swingarm
6. Rear fender
A. Install the clip knob so that it faces to the
outside of the vehicle as shown in the illus-
tration.
B. Face the clamp opening to the outside of
the vehicle.
C. Route the rear wheel sensor lead inside of
the vehicle.
D. Face the clamp opening to the bottom of
the vehicle.
E. Clamp the brake hose and rear wheel sen-
sor lead. Route the rear wheel sensor lead
above the brake hose and face the clamp
opening to the bottom of the vehicle.
F. The clamp position should be in the range
of 30–40 mm (1.18–1.57 in) from the end
of the grommet of the brake hose.
G. Insert the brake hose holder claw firmly
into the swingarm.
H. 10–20 mm (0.39–0.79 in)
I. Insert the holder of the rear wheel sensor
bracket between the ribs behind the rear
wheel sensor protector.
J. Route the rear wheel sensor lead along the
brake hose grommet and then clamp it.
K. 140–150 mm (5.51–5.91 in) (Clamp posi-
tion of the rear wheel sensor lead)
L. 213–233 mm (8.39–9.17 in)
M. 60–80 mm (2.36–3.15 in)
N. Install the metal fitting of the brake hose
(rear brake master cylinder to hydraulic
unit), pushing projection in the direction
shown in the illustration.
O. Route the rear wheel sensor lead to the top
of the vehicle.
P. Inside of the vehicle
Q. Install so that the smaller grommet comes
to the outside of the vehicle.
R. Insert the claw of the rear wheel sensor
lead holder firmly into the stopper hole of
the rear wheel sensor lead stay.