Yamaha Fazer 1000-EXUP, Руководство пользователя

Страница: 42 / 112

5-1
5
EAU00372
5-
OPERATION AND IMPORTANT RIDING POINTS
EAU00373
WARNING
_
●
Become thoroughly familiar
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly
understand.
●
Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
● Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.
_
EAU04710
Starting a cold engine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met.
●
The transmission is in the neutral
position.
●
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
EW000054
WARNING
_
●
Before starting the engine,
check the function of the igni-
tion circuit cut-off system ac-
cording to the procedure
described on page 3-20.
●
Never ride with the sidestand
down.
_
1. Turn the key to “ON” and make
sure that the engine stop switch is
set to “
”.
ECA00108
CAUTION:
_
The oil level warning light, coolant
temperature warning light and fuel
level warning light should come on
for a few seconds, then go off. If a
warning light does not go off, have a
Yamaha dealer check the electrical
circuit.
_
2. Shift the transmission into the neu-
tral position.
NOTE:
_
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical cir-
cuit.
_
3. Turn the starter (choke) on and
completely close the throttle. (See
page 3-11 for starter (choke) oper-
ation.)
U5LVE2.book Page 1 Thursday, June 27, 2002 5:23 PM