Operation
45
2.
Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3.
Turn the main switch to “
” (on).
TIP:
Dual engine users: When the main switch is
turned on, the buzzer operates for a few sec-
onds then stops automatically. The buzzer
also operates if one of the engines stalls.
4.
Turn the main switch to “
” (start),
and hold it for a maximum of 5 seconds.
5.
Immediately after the engine starts, re-
lease the main switch to return it to “
”
(on).
NOTICE:
Never turn the main
switch to “
” (start) while the en-
gine is running. Do not keep the start-
er motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 sec-
onds, the battery will be quickly dis-
charged, thus making it impossible to
start the engine. The starter can also
be damaged. If the engine will not start
after 5 seconds of cranking, return the
main switch to “
” (on), wait 10 sec-
onds, then crank the engine again.
[ECM00192]
EMU36510
Checks after starting engine
EMU36520
Cooling water
Check for a steady flow of water from the cool-
ing water pilot hole. A continuous flow of water
from the pilot hole shows that the water pump
is pumping water through the cooling passag-
es. If the cooling passages are frozen, it may
take a while for water to start flowing out of the
pilot hole.
ON
START
OFF
ZMU01881
U6D625E0.book Page 45 Thursday, March 13, 2008 9:06 AM
