Yamaha F2.5C, Руководство по обслуживанию

Страница: 75 / 184

6D55F11
5-14
1
2
3
4
5
6
7
8
9
3. Install the drive pawls
4
.
4. Install the spring
5
and drive plate
6
,
and then tighten the bolt
7
to the speci-
fied torque.
Installing the starter rope
1. Tie a knot on the end of the starter rope.
NOTE:
Tie a knot at the end of the starter rope as
shown in the illustration.
2. Wind the sheave drum
1
counterclock-
wise until it stops.
3. Turn the sheave drum clockwise until the
rope hole
a
and manual starter roller
b
are aligned. Hold the sheave drum in this
position.
NOTE:
If the sheave drum is turned less than 90°
(from where if stopped to where the rope hole
and roller align), turn it one full turn clockwise
until the hole and roller align again.
4. Pass the starter rope
2
through the rope
hole in the sheave drum and out through
the manual starter case
3
, and then
install the starter rope to the manual
starter handle
4
.
NOTE:
Be sure to leave 12–20 mm (0.47–0.79 in) at
the end
c
of the starter rope.
T
R
.
.
Sheave drum bolt
7
:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
5
6
7
4
4
S6D55360
Power unit