Registration Memory
5
57
Registration numbers cannot be entered beyond the
Registration Shift function's capacity of 80. The following
message momentarily appears when the 80 spaces have been
filled:
First delete unnecessary registrations, then perform the
operation again.
Be careful when using this operation,
since it erases all your existing data.
Always save your important data to a
floppy disk using M.D.R. (page 67) in
advance.
Turning the Electone off erases all panel settings you have made. When
the Electone is turned on, Basic Registration 1 is automatically selected. If
you have made panel settings you wish to keep, save them to Registration
Memory before turning the Electone off. You can, however, restore the
panel settings that were made before the Electone was last turned off. In
doing this, first be careful NOT to press any panel buttons (excepting
those in Basic Registration) after you turn the Electone back on. Then, to
restore the previous settings, hold down the M (Memory) button and press
D (Disable) button.
M.
/TO DISK
1
2
3
4
5
6
7
8
D.
Resetting the Electone to the Factory Preset (Power On Reset)
All current settings including Registration Memories, User voices and User
rhythms can be deleted at once by using the Power On Reset function.
To reset the all settings:
1
Turn off the power.
2
While holding down the top left Data Control button, turn the power
back on.
POWER
Содержание Electone EL-57
Страница 31: ...27 Voice Sections 2 ...
Страница 142: ...138 Appendix 13 MEMO ...