33
E
N
G
L
IS
H
SERVICE INTERVALS
For North American market
TIP
Engine Oil:
8
Oil used in the engine should have an American Petroleum Institute (API) service classification and Proper
SAE Engine Oil according to the ambient temperatures as shown P37.
8
Refer to the following table for the suitable API classification engine oil according to and the fuel.
Fuel used
Engine oil classification (API classification)
Ultra Low Sulfur Fuel [<0.0015% (15 ppm)]
CF, CF-4, CG-4, CH-4
or
CI-4
8
The CJ-4 engine oil is intended for DPF (Diesel Particulate Filter) type engines.
Fuel:
8
Cetane number of 45 minimum. Cetane number greater than 50 is preferred, especially for temperatures
below -20°C (-4°F) or elevations above 1500 m (5000 ft).
8
Diesel fuels specified to EN 590 or ASTM D975 are recommended.
8
No.2-D is a distillate fuel of lower volatility for engines in industrial and heavy mobile service. (SAE J313
JUN87)
8
Since this engine adopts EPA Tier 4 and Interim Tier 4 standards, the use of ultra low sulfur fuel is mandatory
in EPA regulated area (North America). Therefore, please use No.2-D S15 diesel fuel as an alternative to
No.2-D, or use No.1-D S15 diesel fuel as an alternative to No.1-D if outside air temperature is below -10°C
(14°F).
For other than North American market
TIP
Engine Oil:
8
Oil used in the engine should have an American Petroleum Institute (API) service classification and Proper
SAE Engine Oil according to the ambient temperatures as shown P37.
8
With the emission control now in effect, the CF-4 and CG-4 lubricating oils have been developed for use of
a low-sulfur fuel on on-road vehicle engines. When an off-road vehicle engine runs on a high-sulfur fuel, it is
advisable to employ the “CF or better” lubricating oil with a high Total Base Number (TBN of 10 minimum).
8
Refer to the following table for the suitable API classification engine oil according to the fuel.
Fuel used
Engine oil classification (API classification)
High Sulfur Fuel [ 0.05% (500 ppm)]
CF
(If the “CF-4, CG-4, CH-4 or CI-4” lubricating oil is used with a high-
sulfur fuel, change the lubricating oil at shorter intervals. (approximately
half))
Low Sulfur Fuel [<0.05% (500 ppm)] or
Ultra Low Sulfur Fuel [<0.0015% (15 ppm)]
CF, CF-4, CG-4, CH-4
or
CI-4
8
The CJ-4 engine oil is intended for DPF (Diesel Particulate Filter) type engines.
Fuel:
8
Cetane number of 45 minimum. Cetane number greater than 50 is preferred, especially for temperatures
below -20°C (-4°F) or elevations above 1500 m (5000 ft).
8
If diesel fuel with sulfur content greater than 0.5% (5000 ppm) sulfur content is used, reduce the service
interval for engine oil and filter by 50%.
8
DO NOT use diesel fuel with sulfur content greater than 1.0% (10000 ppm).
8
Diesel fuels specified to EN 590 or ASTM D975 are recommended.
8
No.2-D is a distillate fuel of lower volatility for engines in industrial and heavy mobile service. (SAE J313
JUN87)
9CN-9-U1-E0.indd 38
2013/11/19 13:50:54
Содержание EDL7000SE
Страница 2: ......
