Yamaha DVD-S520, Руководство по обслуживанию

Страница: 18 / 90

DVD-S520/DV-S5450
DVD-S520/DV-S5450
ERROR CODES LOOP TEST
ERROR CODE NUCLEUS NUMBER ERROR DESCRIPTION
0601 6 Calculated checksum of FLASH is not correct
0901 9 The DVD DRAM is faulty
1104 11 I2C bus busy before start
1102 NVRAM access time-out
1103 No NVRAM Acknowledge
1104 NVRAM reply time-out
1201 12 I2C bus busy
1202 I2C bus not working
1203 Slave controller not responding
1204 Slave response is not correct
1301 13 Parity error from basic engine to serial
1302 Parity error from serial to basic engine
1303 No communication between serial and basic engine
1304 Communication time-out error
1601 16 The SDRAM is faulty
5201 52
54
5202 Error sending I2C command to COLOR SETUP IC
Error sending I2C command to SCART SWITCH IC
Colour setup IC not responding
Colour setup IC response is not correct
SCART Switch is not responding
SCART Switch response is not correct
5203
5204
5401
5402
5403
5403
I2C bus busy
I2C bus busy
17
4. LOOP TEST
At the start of the loop test, the display will show the result
of the interactive player test:
Figure 28
The left side of the display contains a 3-digit code, which
can have a value between 000 and 111. These values are
to be interpreted as follows:
Displayed
Value Indication for each module
Basic Engine Mono
PCB Display
PCB
000 ok ok ok
001 ok ok faulty
010 ok faulty ok
011 ok faulty faulty
100 faulty ok ok
101 faulty ok faulty
110 faulty faulty ok
111 faulty faulty faulty
Figure 29
The loop test will perform the same nuclei as the dealer
test, but it will loop through the list of nuclei indefinitely.
The display of the DVD player will display not only the
three digits indicating correct/faulty modules and the last
found error code (as mentioned, faults are detected as far
as they can be within the scope of the diagnostic
software), but also a loop counter indicating how many
times the loop has been gone through.
Example:
FAULTY
MODULE(S) LOOP
COUNTER NUCLEUS ERROR
Figure 30
The number after the hyphen indicates the number of
times the loop test has been performed; the 4 digits at the
right side of the display show the last error that was found
when running the loop test: the leftmost two digits of this
code indicate which nucleus resulted in a fault; the
rightmost two digits refer to the faultcode within that
nucleus. For further explanation of this error code, see list
of error codes below.
Figure 31