3
Notes for DME64N/DME24N Version 1.2
MODE: Summing
Sums all input signals coming from Inputs (-12dB), without regard to
device or card type, and outputs it through all Outputs.
■
The Event Scheduler function allows day/time settings for events
The settings are accessible via the Utility display “Misc” page.
Refer to the “DME Designer Version 1.2 Owner’s Manual” for details.
Event Scheduler
Determines whether an event schedule setup in the DME Designer
will be executed or not, and displays the current status.
ON:
The event will be executed.
OFF:
The event schedule will not be executed.
■
A DAW control function has been added.
With this function you can control the DME64N/24N from a DAW controller.
1. Parameter Control Function
Lets you control DME64N/24N parameters using a DAW Controller.
For example, if the PAN parameter is assigned to CH1 of the DAW controller, you can control the PAN parameter by
operating a knob.
There are two modes in the parameter control function, as follows:
(1) General Parameter Operation Mode
[KNOB] and [CH FADER] controls are used to operate internal parameters assigning them in DME Designer.
For detailed settings, see the “DME Designer Version 1.2 Owner’s Manual.”
(2) Final Output Stage Parameter Operation Mode
Final output stage parameters are operated using [MUTE] and [CH FADER] controls.
Unlike the General Parameter Control Mode, controls and the parameters that are compatible with them, are fixed in this
mode.
[Method of Operation]
[
▲
]:
Switches to General Internal Parameter Control Mode.
[
▼
]:
Switches to Final Output Stage Parameter Control Mode.
[BANK <][BANK >]:
The channels targeted for operation are shifted by the number of channels built into the DAW
controller.
[CH <][CH >]:
The channels targeted for operation are shifted one channel at a time.
[SELECT]:
Switches the display method on the DAW controller.
When turned OFF, an overall display appears. When a channel is turned ON, the detail display appears for that channel.
For information about the overall and detail displays, see the next item, “Setting and Parameter Name Display Function.”
[KNOB]:
Changes assigned parameters in the General Internal Parameter Operation Mode.
This is not used in the Final Output Stage Parameter Operation Mode.
[MUTE]:
This is not used in the General Internal Parameter Operation Mode.
This turns muting ON or OFF for the corresponding channel in the Final Output Stage Parameter Operation Mode.
[CH FADER]:
Changes assigned parameters in the General Internal Parameter Operation Mode.
This adjusts volume for the corresponding channel in the Final Output Stage Parameter Operation Mode.
2. Setting and parameter name display function
Displays the settings and parameter names on the DAW controller’s LCD screen.
There are two display methods: over-all display and detail display.
Overall Display:
The overall display shows the assigned parameter names and settings, organized by DAW channels.
Detail Display:
In the detail display, you select the parameter you want to display. Only information for that parameter
appears on the DAW controller’s LCD screen.
NOTE
Only one parameter can be assigned to the same channel.
NOTE
The number of characters that can be displayed is limited by the size of the DRAW’s LCD screen.
