Getting Started
2
Chapter
15
Note:
To check whether your wireless
router (access point) supports WPS,
refer to the owner’s manual supplied
with your wireless router (access
point).
If your wireless router (access point) supports WPS, you can easily
connect the Disklavier to a network just by following the procedures below,
without making any additional settings, such as entering a password.
Press the POWER
button to turn the power off.
Connect the USB wireless LAN adaptor (UD-WL01) to the
USB port on the rear of the switch box.
Check that the WLAN switch on the rear of the switch box
is set to “RT.”
Press the POWER
button to turn the power on.
Hold down the WPS button on the USB wireless LAN
adaptor (UD-WL01) for at least five seconds.
The LED lamp on the USB wireless LAN adaptor (UD-WL01)
flashes every 0.5 seconds.
Wireless Network Connection by WPS
1
2
LED l
a
mp
WP
S
bu
tton
WLAN
s
witch
3
4
5