Yamaha DHR 10, Руководство пользователя

Страница: 6 / 24

6
Controls and Connectors
q
Input jacks (CH1 and CH2)
These are balanced combo jacks that support both XLR
and phone plugs (both CH1 and CH2), and RCA pin
plugs (CH2 only). For the combo jacks, connect a mixer,
microphone, or digital musical instrument such as a key-
board. For RCA-pin jacks, connect a device such as an
MP3 player or a CD player. For devices with high level sig-
nals such as a mixer, connect to CH2, or connect to CH1
then set the [MIC/LINE] switch (
w
) to [LINE].
w
[MIC/LINE] switch
Set this switch to [MIC] or [LINE] for the CH1 jack,
depending on the level of the input signal. For low-level
signals (such as microphones), set the switch to [MIC].
For high-level signals (such as mixer), set the switch to
[LINE].
e
[LEVEL] knobs
Adjust the level of each input jack (
q
).
r
Output switch
Selects the output signal sent to the output jack (
t
).
[CH1 THRU]: Delivers the direct output signal of CH1 only.
Signal from CH2 will not be output.
[CH1+2 MIX]: Outputs the mixed signals of CH1 and CH2.
t
Output jack
This is a balanced XLR jack. This can be used to connect
another DHR speaker. Outputs the signal selected by
r
output switch.
!3
!3
!2
!1
y
u
i
o
!5
r
t
q
!0
!4
e
w
Rear
For CH2, inputs to the combo jack and to the RCA pin jacks will
be mono mixed at a fixed balance. If you want to change the bal-
ance, adjust the volume of the connected sound source.
XLR Phone RCA-pin
NOTE