4
Battery Replacement
When the remote control fails to work from a
distance, replace the batteries.
•
Replacement batteries should be UM-3, AA,
R6P, or LR6 type.
•
Always replace both batteries.
•
If the remote control is not to be used for a
prolonged period of time, remove the batteries
to prevent possible damage by battery leakage.
Important:
Be sure to read the section on Handling
Batteries on page ii of “Important” for
details on the safe handling of dry
batteries.
Using the Remote Control
To use the remote control, point it at the remote
control sensor on the Control Unit.
Connecting Other
Equipment
☛
To connect audio instruments to the AUX connectors,
see Chapter 13 “Using the AUX Connectors.”
☛
To connect MIDI equipment, tone generator, or a
synthesizer to the Disklavier GranTouch, see
Chapter 10 “The Disklavier GranTouch & MIDI”
in the
Advanced Operation Manual
.
☛
To connect a personal computer to the Disklavier
GranTouch, see Chapter 11 “The Disklavier
GranTouch & Personal Computers” in the
Advanced Operation Manual
.
Using the Remote
Control
The Disklavier GranTouch is equipped with a
remote control which allows convenient control
from almost anywhere in the room.
Installing Batteries in the
Remote Control
Before the remote control can be used, the two
batteries supplied with the Disklavier GranTouch
must be installed.
Remove the battery cover from the rear of the
remote control, install the batteries, and then
replace the cover.
A diagram inside the battery compartment shows
which way the batteries should be installed. Make
sure you insert them correctly.
PLAY/PA
USE
STOP
REC
SONG S
ELECT/
REV • FW
D
PART
L
R
ENTER
VOICE
FUN
CONTRO
L UNIT D
KC55RC
D
GENER
AL
INSTRU
MENT
STANDB
Y
ON
SELECT
DRIVE
30˚
30˚
Approx. 5 m (16 ft.)