Yamaha D'elight, Руководство пользователя

Страница: 46 / 80

Perio d ic maintenance an d a d justment
6-12
6
NOTICE:
When removin g the
en g ine oil d rain b olt B, the O-
rin g , compression sprin g , an d
oil strainer will fall out. Take
care not to lose these parts.
[ECAT1022]
4. Clean the engine oil strainer with
solvent, and then check it for dam-
age and replace it if necessary.
5. Install the engine oil strainer, com-
pression spring, new O-ring and
engine oil drain bolt B.
TIP
Make sure that the O-ring is properly
seated.
6. Install engine oil drain bolt A and
its new gasket, and then tighten
both drain bolts to their specified
torques.
7. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11671
z
Do not use oils with a d iesel
specification of “CD” or oils of a
hi
g her quality than specifie d . In
a dd ition, d o not use oils la b ele d
“ENERGY CONSERVING II” or
hi
g her.
z
Be sure no forei g n material en-
ters the crankcase.
8. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
9. Turn the engine off, and then
check the oil level and correct it if
necessary.
1. Engine oil drain bolt A
2. Engine oil drain bolt B
1. Oil strainer
2. Compression spring
3. O-ring
4. Engine oil drain bolt B
2
1
ZAUV045 8
3
4
Ti g htenin g torque:
Engine oil drain bolt A:
20 N·m (2.0 kgf·m, 15 lb·ft)
Engine oil drain bolt B:
20 N·m (2.0 kgf·m, 15 lb·ft)
Recommen d e d en g ine oil:
See page 8-1.
Oil quantity:
0.80 L (0.85 US qt, 0.70 Imp.qt)
UBW5E0E0.book Page 12 Tuesday, November 22, 2016 4:44 PM