CL Editor Owner’s Manual
13
4
Ø (Phase)
Inverts the phase polarity of the signal after AD conversion.
5
Digital Gain
Drag the knob in the screen to adjust the input gain of each input channel.
6
HPF (High Pass Filter)
Switches the high pass filter on/off. You can drag the numeric value up or down to edit the
cutoff frequency.
7
INSERT
Enables/disables the insert-in.
8
D. OUT (Direct out)
Enables/disables the direct output.
9
EQ (Equalizer)
Switches the EQ on/off. The graph immediately below the button shows the approximate
response of the EQ. Double-click within the graph to open the Selected Channel window of
the corresponding channel. To open the Selected Channel window as an additional view,
hold down the <Ctrl>(<
>) key of your computer keyboard and double-click the graph.
0
DYNA1/DYNA2 (Dynamics 1/Dynamics 2)
Turns the two dynamics processors on/off.
If Gate is assigned (Dynamics 1 only), the status of the gate is shown immediately below the
button.
If something other than Gate is assigned, a GR meter is shown immediately below the but-
ton, and the amount of gain reduction is shown while this is on.
The type for each dynamics processor can be selected in the Selected Channel window.
Double-click anywhere other than the DYN1 or DYN2 button to open the Selected Channel
window of the corresponding channel. To open the Selected Channel window as an addi-
tional view, hold down the <Ctrl>(<
>) key of your computer keyboard and double-click
anywhere other than the DYN1 or DYN2 button.
A
DELAY
Turns the input delay processors on/off. The current delay value is shown in the numerical
box located immediately below the button. You can also edit the delay value in this text box.
B
MIX/MATRIX (MIX/MATRIX SEND)
Switches between the send indications to MIX buses 1–24 and to MATRIX buses 1–8.
The bar graphs located immediately below the button show the send level of the signals sent
from the INPUT CH to VARI type MIX/MATRIX buses. You can also drag the bar graph to
left or right to set the send level. While you drag the bar graph, the send level is shown in the
numerical display area for PAN/TO STEREO MONO (
C
).
You can set the minimum value (–∞ dB) by holding down the <Ctrl>(<
>) key of your
computer keyboard and clicking the bar graph, or set the nominal value (0.00 dB) by hold-
ing down the <Ctrl>(<
>) key and <Shift> key and clicking the bar graph.
The bar graph display will change according to the send position (pre/post) and on/off sta-
tus of the signal sent from the INPUT CH to the MIX/MATRIX buses.
To switch a send on/off, click the channel number located at the left of the bar graph.
For FIXED-type MIX buses, the bar graph is fixed at nominal level (0 dB),
and only the on/off status is shown.
In SENDS ON FADER mode, this button enables you to adjust the send
level using the fader.
Gate status
indication
On/off status
On
On
On
Off
Open/closed
status
Closed
Open
Open
—
Remarks
Gain reduction amount
is 30 dB or more
Gain reduction
amount is 0–30 dB
Gain reduction
amount is 0 dB
—
4
5
6
7
8
9
0
B
A
Pre/on (green)
Pre/off (green)
Post/on (orange)
Post/off (orange)
NOTE
NOTE
